b'HaasTooling.comMeasuring & InspectionMicrometersV-Anvil Micrometer - Digital OnlyV-AnvilMicrometers are specialized for measuring cutting tools or parts with an odd number of flutes, where a direct diameter reading is not possible. V-angles for 3-flute and 5-flute availableAvailable in different sizes Carbide measuring tips2 Anvil types - flat & pointed Ratchet stop metric thimbleDigital resolution:0.001mmMade in accordance with DIN 863(0.00005") Battery type: CR2032Graduation: 0.01 mm IP rated for dust and liquid Stainless steel spindle resistance.Spindle thread is hardened, ground, and lapped for ultimate accuracyInternal Groove Micrometer - Standard OnlyAn Internal Groove Micrometer is used for measuring grooves or notches found on the inside diameter of parts. Two flange-shaped anvils make getting into hard-to-reach features easy, providing an accurate measurement.Available in inch (U.S. only) & metricFriction thimbleProvides constant resistance for consistent pressure during measurementsMade in accordance with DIN 863Non-rotating spindleUniversal Micrometer - Digital OnlyNeed one micrometer that can do it all and provides a high degree of accuracy and precision? The Haas Universal Micrometer includes 7 interchangeable anvil types that can be used for measuring a variety of features and parts.Available in 2 universal ranges Made in accordance withRatchet stop thimble DIN 863Stainless Steel Spindle Battery type: CR2032Spindle thread is hardened,7 pairs of anvilsSpline, disc, ground, and lapped for blade, 60 knife-edge, 60 point, ultimate accuracy spherical, and flat.72 | Get up to 8% off with Winners Circle'